This a custom bracket that brings the Clover Flex 3 POS device next to the 19" - 23" Tablet. The bracket, made of metal with a black coating is secured to the back of the monitor and projects to the left or the right of the monitor. The mount comes with all of the mounting screws for the install. The POS mount on the bracket has holes for both 70mm and 100mm VESA mounts. VESA mounts are the four screw holes that come standard on the back of a monitor/display.

WILL IT FIT? Measure from the center of the four VESA mounting holes on the back of your monitor to the edge of the monitor. If you are keeping the swiper on the POS/Monitor, then measure past the swiper. This mount will extend either 9.5" or 10.5" from the center of your monitor.

Insert Clover Flex 3 POS and tighten the bolt on the back of the plate to lock the POS in place.

Fits Clover Flex 3 P/N C405 POS. Stand is not compatible with the original version of the Clover Flex C401U POS device.

Come with a set of (2x) screws:

M4 x 10mm - 2x screws - Small

The mount does not include the terminal.

Tools needed for the install: Phillips Head Screwdriver.

Click HERE for VESA Schematic Diagram.

Click HERE for VESA Installation Instructions.

Custom Plates already produced for these PINPads:

Clover Flex, Ingenico Lane/3000/5000/7000/8000, IPP310, IPP315, IPP320, IPP350; RP10, FD35/FD40, PAX A34, S300/SP30, PAX A35, A920/A920 Pro, P200, Vx805, Vx820, Z3, Z6, AND V200/V400.
Also available in a 15"/17" mount

If you want to use it with any other PINpad, there is a 25 unit minimum.